Coral Pegs and How To Use Them
Step 1
Use a 5/16 (11mm) drill bit to make a hole in the bottom of the coral approximately 1" deep.
Step 2
Gently screw the peg into the bottom of the coral. About half of the peg should be in the coral, leaving 1" of the peg sticking out.
Step 3
(Optional ): Use the same size drill bit (5/16" or 11mm) to drill a hole in the rock where you want to place coral if no suitable holes exist in the rock already.
Step 4
Gently push the free end of the peg into a suitable hole, holding the coral in place.
